Call me

Have a Query? We will call you right away.

+91

E.g: 9876543210, 01112345678

We will give you a call shortly, Thank You

Office hours: 9:00 am to 9:00 pm IST (7 days a week)

What are you looking for?

Syllabus

State the principal and working of a meter bridge?

The four arms ABCD of a Wheatstones network have the following resistances:

AB = 2 Ω, BC=4 Ω, CD= 4 Ω and DA= 8 Ω. A galvanometer of resistance 10 Ω is

connected between B and D. Find the current through the galvanometer, when

the potential difference between A and C is 5 V.

On what factors the internal resistence of a cell depends ?

Draw an equipotential surface due to an electric dipole.

A 3 m long copper wire carrying a current of 3 A.. How long does it take for an electron to drift from one end to other end ? The cross- sectional area of the wire is 2 * 10 ^ -6 m

^{2}and the number of conduction electrons in copper is 8.5 * 10 ^ 28 m^{-3}.why are alloys manganin constantan used to make standard resistance coil?

Solve this :82. The equivalent resistance of the circuit between points O and A is

$\left(1\right)\frac{12\mathrm{R}}{13}\left(2\right)\frac{\mathrm{R}}{13}\phantom{\rule{0ex}{0ex}}\left(3\right)\frac{5\mathrm{R}}{13}\left(4\right)\frac{15\mathrm{R}}{13}$

project onto study various factors on which the internal resistance/emf of a cell depends.

Define 1 Ampere.

derivation for ampere circuital law?

How is I=Qv and I=QA please explain. these formulae have been used in my guide.

How to solve an unbalanced Wheatstone bridge?

the resistance of a silver wire at 0 degree celsius is 1.25 ohm.upto wat temp. it must b heated so dat its resistance is doubled?(alpha silver=0.00375/degree celsius.will d temp. be same for all silver conductors of all shapes??

how can sensitivity of potentiometer be increased

What is the dimensional formula of potential difference

What is the definition of meter bridge?

Two conductors one having resistance R and another 2R are connected in turn across a d.c.source.If the rate of heat produced in two conductors is Q

_{1}and Q_{2 }respectively, what is the value of Q_{1}/Q_{2}?What are the conditions for total internal reflection?

ans is 6*10^-4, 3.75*10^15

the emf of a cell is always greater than its terminal voltage.why?give reason.

why is potentiometer preferred over voltmeter?

what is the dimension of resistance....????

a copper wire is streched to make it 0.1%lonnger.what is the percentage change in resistance?

what is vacus junction?

derive relation between current density and potential difference across a current carrying conductor of length l,area of cross section A and number density of free electron n

A balloon starts rising from ground rest with an upward acceleration 2 m/secsqu. just after 1 sec. a stone is dropped from it the time taken by stone to strike the ground is nearly?

Find the value of the unknown resistance X in the circuit of fig. if no current flows through the section AO. Also calculate the current drawn by the circuit from the battery of emf 6 V and negligible internal resistance

the resistance of the platinum wire of a platinum resistance thermometer at the ice point is 5 ohm and at steam point is 5.23 ohm .When the thermometer is inserted in a hot bath , the resistance of the platinum wire is 5.795 ohmcalculate the temprature of the bath

what are the advantages of potentiometer over votlmeter ?

show that electric field is conservative?

the reading on a high resistance voltmeter when a cell is connected across it is 2.2 v . When the terminal of the cells are also connected to a resistance of 5 v ,the voltmeter reading drops to 6.8 v . Find the internal resistance of the cell?????1) 2:3

2) 2:1

3) 1:2

4) 1:1

1)60 W bulb will fuse. 2)100 W bulb will fuse 3)both bulbs will fuse.

4)Bulbs will not fuse

Three cells of emf 2V,1.8V and 1.5V are connected in series.Their internal resistances are 0.05ohm, 0.7ohm and 1ohm respectively.If the battery is connected to an external resistor of 4ohm via a very low resistance of ammeter, what would be the reading in the ammeter?

In a galvanometer there is deflection of 10 divisions per mA.Thje internal resistance of the galvanometer is 60 ohm.If a shunt of 2.5 ohm is connected to the galvanometer and there are 50 divisions in all,on the scale of galvanometer,what maximum current can this galvanometer read?

MY DOUBT IS:(If wrong plz correct it and explain) Since there are 50 divisions in all in the galvanometer,then maximum current that galvanometer would read is I_{g}=50*1/10=5 mA .But the answer is given 125 mA.How?how does drift velocity of electron in a metallic conductor vary with temperature?

Q.8. For the given circuit find out the -

(a) total resistance of the circuit across the battery terminals.

(b) potential difference between A and B.

A steady current flows in a metallic conductor of non-uniform cross section.Which of these quantities is constant along the conductor-

1)Current

2)Current density

3)Drift speed

4)Electric field

why is it safe to sit inside a car during a thunderstorm ?

A resistance or R ohm draws a current from a potentiometer.The potentiometer has a total resistance R

_{0}ohm.A voltage V is supplied to the potentiometer .Derive an expression for the voltage fed to the ckt when the slide is in the middle of the potentiometer.A 200-V bulb takes a current of 0.2 A. The length of its filament is 22 cm and the specific resistance of the material of the filament is 7 * 10^-5 ohm-cm. Find the radius of the filament. (pi=22/7)

A wire of resistance 8R is bent in the form of a circle. What is the effective resistance between the ends of a diameter AB?

A 80uF capacitor is charged by a 50V battery.The capacitor is disconnected from the battery and then connected across another uncharged 320 uF capacitor. Calcuulate the charge on the second capacitor.

Explain the variation of conductivity nwith temp for (a) A metallic conductor (b) ionic conductor

Q.53. In the circuit shown in figure, find the current through the branch BD.

(1) 1 A

(2) 5 A

(3) 3 A

(4) 7 A

Two conducting wires X and Y of same diameter but different material are joined in series across the battery. If the number density of electron in X is twice that in Y, fined ratio of drift velocity of electron in two wires

a uniform wire of resistance 36 ohm is bent in tne form of a circle .calculate the effective resistance across the points A and B.

is current is scalar or vector quantity?

current I is flowing through the two materials having electrical conductivities sigma1 and sigma2 respectively (s1 > s2 ) as shown in the figure. The total amount of charge piled at the junction of the materials is

The supply voltage to a room is 120V.The resistance of lead wires is 6 ohm.A 60 W bulb is already switched on.What is the decrease of voltage across the bulb when a 240 W heater is switched on in parallel with the bulb?

a)0 V b)2.9 V c)13.3 V d) 10.04 V

Thank you

Q. Find the current through the 10 ohm resistance connected across AB.

My Question:

Draw V-I Graph for both ohmic and non-ohmic materials stating one example of each as well.thanks!

a wire of 15 ohm resistance is gradually stretched to double its original length. it is then cut into two equal parts. these parts are connected in parallel across a 3 V cell. find the current drawn from the cell

A storage battery of emf 8V and internal resistance 0.5 ohm is being charged by a 120 V d.c supply using a series resistor of 15.5 ohm. What is the terminal voltage of the battery during charging? what is the purpose of having a series resistor in the charging ciruit?

12 identical resistance R each form a cube . Resistance across its face diagonal corners is?

Draw the circuit diagram and using Kirchhorf's laws, calculate the current through each branch of the circuit and potential difference across the 5 ohm resistor.

derive the expression for drift velocity in an electric field.

what are kirchhoff's law?explain them.

give two possible causes for one sided deflection in a potentiometer experiment.

A piece of copper of mass 50 g is drawn into a wire of length 50 m. Find the resistence of the wire . The density and specific resistence of copper are 8.9 * 10^3 kg m^-3 and 1.7 * 10^-8 ohm-m

why is a copper wire used in a sonometer to find the frequency of A.C mains?plz i hv my board practicals 2morow.friends and xperts plz help

1 NEWTON =how many dyne?

A cylindrical metallic wire is stretched to increase its length by 5%. Calculate the percentage change in its resistance.

what is the main difference between DC n AC current???

(1).Diode

(2).Thyristor

(3).PN junction system

(4).All of these